217
Views
System view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an ACL by its number in the range of 2000 to 2999.
name acl-name: Specifies an ACL by its name. The acl-name argument is a case-insensitive string
of 1 to 63 characters. It must start with an English letter and to avoid confusion, it cannot be all. The
specified ACL must be an IPv4 basic ACL that has already been created.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
Only NETCONF clients permitted by the applied ACL can access the device through SOAP over
HTTPS.
Examples
# Use ACL 2001 to allow only NETCONF clients in the subnet 10.10.0.0/16 to access the device
through SOAP over HTTPS.
<Sysname> system-view
[Sysname] acl basic 2001
[Sysname-acl-ipv4-basic-2001] rule permit source 10.10.0.0 0.0.255.255
[Sysname-acl-ipv4-basic-2001] quit
[Sysname] netconf soap https acl 2001
New feature: Specifying a backup traffic processing unit
Specifying a backup traffic processing unit
This release added support for specifying a backup traffic unit for an interface.
Command reference
service standby
For more information about this command, see HPE FlexNetwork MSR Command References(V7).
To Next Page
Loading...
