HPE MSR1000

82
Table 4 Command output
Field
Description
IKEv2 policy Name of the IKEv2 policy.
Priority Priority of the IKEv2 policy.
Match local address IPv4 address to which the IKEv2 policy can be applied.
Match local address ipv6 IPv6 address to which the IKEv2 policy can be applied.
Match VRF VPN instance to which the IKEv2 policy can be applied.
Proposal IKEv2 proposal that the IKEv2 policy uses.
Related commands
ikev2 policy
New command: display ikev2 profile
Use display ikev2 profile to display the IKEv2 profile configuration.
Syntax
display ikev2 profile [ profile-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
profile-name: Specifies an IKEv2 profile by its name, a case-insensitive string of 1 to 63 characters. If
you do not specify an IKEv2 profile, this command displays the configuration of all IKEv2 profiles.
Examples
# Display the configuration of all IKEv2 profiles.
<Sysname> display ikev2 profile
IKEv2 profile: 1
Priority: 100
Match criteria:
Local address 1.1.1.1
Local address GigabitEthernet1/0/1
Local address 1:1::1:1
Remote identity address 3.3.3.3/32
VRF vrf1
Inside VRF: vrf1
Local identity: address 1.1.1.1
Local authentication method: pre-share