HPE MSR1000

126
Modified command: display ipsec { ipv6-policy | policy }
Syntax
display ipsec { ipv6-policy | policy } [ policy-name [ seq-number ] ]
Views
Any view
Change description
The following fields were added to the command output:
•
Traffic Flow Confidentiality—Whether Traffic Flow Confidentiality (TFC) padding is enabled.
•
IKEv2 profile—IKEv2 profile used by the IPsec policy.
Modified command: display ipsec { ipv6-policy-template | policy-template }
Syntax
display ipsec { ipv6-policy-template | policy-template } [ template-name [ seq-number ] ]
Views
Any view
Change description
The following fields were added to the command output:
•
Traffic Flow Confidentiality—Whether Traffic Flow Confidentiality (TFC) padding is enabled.
•
Selector mode—Data flow protection mode of the IPsec policy template.
•
Local address—Local end IP address of the IPsec tunnel.
•
IKEv2 profile—IKEv2 profile used by the IPsec policy template.
•
SA idle time—Idle timeout of the IPsec SA, in seconds.
Modified command: display ipsec sa
Syntax
display ipsec sa [ brief | count | interface interface-type interface-number | { ipv6-policy | policy }
policy-name [ seq-number ] | profile profile-name | remote [ ipv6 ] ip-address ]
Views
Any view
Change description
The following fields were added to the command output:
•
Extended Sequence Number enable—Whether Extended Sequence Number (ESN) is
enabled.