HPE MSR1000

190
Change description
Layer 3 Ethernet subinterface view was added.
A Layer 3 Ethernet subinterface can belong to only one aggregation group.
You cannot create subinterfaces on a Layer 3 Ethernet interface that is in an aggregation group. You
cannot assign a Layer 3 Ethernet interface that contains subinterfaces to an aggregation group.
When you assign a Layer 3 Ethernet subinterface to an aggregation group, follow these restrictions
and guidelines:
•
As a best practice, configure the VLAN termination commands on the subinterface first if VLAN
termination is required. VLAN termination configuration on the subinterface cannot be modified
after the subinterface is assigned to an aggregation group.
•
Make sure the VLAN termination configuration is the same on all Layer 3 Ethernet
subinterfaces when you assign the subinterfaces to the same aggregation group.
•
When you configure the vlan-type dot1q vid vlan-id-list [ loose ] command on a subinterface
to be assigned a dynamic aggregation group, make sure the vlan-id-list argument specifies only
one VLAN ID.
You cannot assign Layer 3 Ethernet interfaces and Layer 3 Ethernet subinterfaces to the same
aggregation group.
You cannot create aggregate subinterfaces on a Layer 3 aggregate interface whose corresponding
aggregation group uses Layer 3 Ethernet subinterfaces as member ports. You cannot assign Layer 3
Ethernet subinterfaces to an aggregation group whose corresponding aggregate interface has
aggregate subinterfaces.
Modified feature: Changing the maximum number of FIB
table entries
Feature change description
The maximum number of FIB entries that MSR2003 supports for the IPv4 public network is changed
to 300000.
The maximum number of FIB entries that MSR2003 supports for the IPv6 public network is changed
to 300000.
Command changes
None