HPE MSR1000

237
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
New feature: Support of MFR and FR for L2VPN, FR QoS,
and FR compression and fragmentation
Configuring Support of MFR and FR for L2VPN, FR QoS, and FR
compression and fragmentation
Frame Relay supports MPLS L2VPN and can then communicate with other networks through MPLS
L2VPN. As a result, Layer 2 data can be transparently transmitted between Frame Relay networks
through an MPLS or IP network.
When FRTS is disabled, only FR interface queues are in effect. The predefined FR PVC queues take
effect only when FRTS is enabled.
The Frame Relay compression feature can compress Frame Relay packets to save bandwidth,
reduce the network load, and improve the transmission efficiency for data in the Frame Relay
network. The Frame Relay fragmentation feature can divide a large Frame Relay packet into several
small packets, so that large packets can be transmitted over a low-speed link with a low delay.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).
New feature: Support for LLDP on CPOS interfaces
Configuring Support for LLDP on CPOS interfaces
LLDP is supported on CPOS interfaces.
Command reference
See HPE FlexNetwork MSR Configuration Guides(V7) and HPE FlexNetwork MSR Command
References(V7).