HPE MSR1000 - Page 31

27
201601210332
•
Symptom: After a subcard is removed and the router is rebooted, the interface indexes for the
subcard change in the MIB.
•
Condition: This symptom might occur if a subcard is removed and the router is rebooted.
201601180511
•
Symptom: When OpenFlow is enabled, application layer processing is slow and packet loss
occurs.
•
Condition: This symptom might occur if OpenFlow is enabled.
201603290254
•
Symptom: The router reboots unexpectedly if it has 4 GB of memory.
•
Condition: This symptom might occur if the router has 4 GB of memory.
201602290118
•
Symptom: The route filtering settings of RIP processes running in VPNs are lost after the
running configuration is saved and the router is rebooted.
•
Condition: This symptom might occur if one of the following operations is performed:
 Upgrade the software and reboot the router.
 Use a .cfg configuration file when rebooting the router.
201602260072
•
Symptom: An L2TP LAC does not have uplink traffic statistics for users.
•
Condition: None.
201602200075
•
Symptom: PPPoE clients fail to come online when the router acts as the PPPoE server if the
DNS server IP address is an IPCP configuration option in IPCP negotiation.
•
Condition: This symptom might occur if the DNS server IP address is an IPCP configuration
option in IPCP negotiation.
201602010352
•
Symptom: When network congestion occurs, high-priority packets are dropped on a
CBQ-enabled MP link.
•
Condition: This symptom might occur if CBQ is configured for an MP link, and network
congestion occurs.
201602150740
•
Symptom: 4G dialup fails if an APN profile specifies the username and password.
•
Condition: This symptom might occur if an APN profile specifies the username and password
for 4G dialup.
201604060109
•
Symptom: No information can be obtained from the 4G MIB.
•
Condition: None.
201604070435
•
Symptom: An HMIM module might drop packets or stop forwarding traffic.
•
Condition: None.