EasyManua.ls Logo

HPE MSR1000 - Page 34

HPE MSR1000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
201602240243
Symptom: The router might reboot unexpectedly after running for 497 days.
Condition: None.
201602010060
Symptom: RIP route filtering settings on the router are lost after the running configuration is
saved and the router is rebooted.
Condition: This symptom might occur if one of the following operations is performed:
Upgrade the software and reboot the router.
Use a .cfg configuration file when rebooting the router.
201603090066
Symptom: An ADVPN tunnel cannot be set up if a loopback interface provides the tunnel source
address and the physical tunnel outgoing interface is a NAT-enabled PPPoE dialer interface.
Condition: This symptom might occur if a loopback interface provides the tunnel source address
and the physical tunnel outgoing interface is a NAT-enabled PPPoE dialer interface.
201603090064
Symptom: The DVPN service is interrupted during IPsec SA renegotiation.
Condition: This symptom might occur if the IPsec SA expires and IPsec SA renegotiation is
performed.
201603020540
Symptom: The memory usage keeps rising if no ACL is specified for an IPsec policy template.
Condition: This symptom might occur if no ACL is specified for an IPsec policy template.
201601120419
Symptom: An NMS returns an error when it reads the 3G modem table from the MIB of the
router.
Condition: This symptom might occur if two SIC-3G cards are installed on the router.
201601160235
Symptom: The router as a PPPoE server has duplicate PPPoE client information.
Condition: None.
201601180617
Symptom: The global DHCP address pool usage is incorrect.
Condition: None.
201601260049
Symptom: The router reboots unexpectedly when it receives GRE packets with the DF bit set.
Condition: This symptom might occur if the router receives GRE packets with the DF bit set.
201601190036
Symptom: The secondary IP addresses of a Virtual-Template interface are unavailable.
Condition: None.
201601210335
Symptom: The PPP IP segment match feature does not take effect if the
user-basic-service-ip-type { ipv4 | ipv6 | ipv6-pd } command is not configured.

Table of Contents

Related product manuals