EasyManua.ls Logo

HPE MSR1000 - Page 37

HPE MSR1000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
Symptom: CVE-2015-7705
Condition: Denial of Service by Priming the Pump.
Symptom: CVE-2015-7855
Condition: Denial of Service Long Control Packet Message.
Symptom: CVE-2015-7871
Condition: NAK to the Future: NTP Symmetric Association Authentication Bypass Vulnerability.
201507140251
Symptom: VRRPv3 does not support packet authentication. However, no error is displayed
when packet authentication is configured for VRRPv3.
Condition: None.
201505270318
Symptom: No prompt is displayed when the router finishes downloading a file as an FTP client.
Condition: This symptom occurs if the downloaded file is greater than 2147483647 bytes.
201512300140
Symptom: NTP time synchronization fails between the router and a Cisco device with a time
accuracy of 2
32
.
Condition: This symptom occurs if NTP time synchronization occurs between the device and a
Cisco device with a time accuracy of 2
32
.
201507210022
Symptom: IPsec RRI cannot be implemented based on negotiated traffic flow in the IPsec VPN.
Condition: None.
201511260648
Symptom: Traffic cannot be forwarded through ADVPN tunnels.
Condition: This symptom occurs if ADVPN tunnels are established over an IPv6 network.
201511300165
Symptom: The results of tests that FIPS performs for 3DES and AES-wrap are unexpected.
Condition: None.
201507020257
Symptom: The DF bit setting in IPsec packets does not take effect.
Condition: This symptom occurs if the DF bit of IPsec packers is set on the source interface
bound to an IPsec policy.
201512091595
Symptom: IKEv2 uses protocol number 5000 instead of 4500.
Condition: This symptom occurs if IKEv2 NAT traversal is configured.
201510080297
Symptom: The router fails to perform PPTP dial-up.
Condition: This symptom might occur if the router accesses the PPTP server through the NAT
server.
201512100696
Symptom: The OpenFlow controller fails to discover the router during topology discovery.

Table of Contents

Related product manuals