46
201507020251
Symptom: A PW is re-created after the L2VPN process is re-optimized by using the placement
reoptimize command.
Condition: This symptom occurs if split horizon is enabled for the PW.
201506300136
Symptom: An interface on the SIC-4GSW card cannot ping the directly connected interface on
the same subnet after the interface is changed to a Layer 3 interface.
Condition: This symptom occurs if the following operations are performed:
a. Enable port security globally.
b. Configure port security on the interface operating as a Layer 2 interface.
c. Change the interface to a Layer 3 interface.
201505290258
Symptom: Subinterfaces cannot be created or deleted when there are more than 4000
subinterfaces on the router.
Condition: This symptom might occur if the following operations are performed:
a. Perform an active/standby switchover.
b. Restart the standby MPU.
c. Change a main interface between Layer 2 mode and Layer 3 mode.
d. Bring up and shut down the main interface.
201507170043
Symptom: A router in an MPLS network reboots unexpectedly.
Condition: This symptom occurs if the public interface of the router goes down and comes up
repeatedly.
201507030323
Symptom: Memory leaks.
Condition: This symptom occurs if NETCONF is used to download files for the FileSystem
node.
201506190348
Symptom: The xmlcfgd process crashes.
Condition: This symptom occurs if the xmlcfgd process is accessed through XML when there is
no Envelope namespace.
201506190151
Symptom: The router does not preferentially use static address allocation when receiving a
DHCP-INFORM message from a client.
Condition: This symptom occurs if the following conditions exist:
The client is bound to an IP address in a DHCP address pool.
Another DHCP address pool includes the IP address bound to the client.
201506100354
Symptom: The router configured with WAAS sends a receiving buffer size different from the set
value to the peer device.
Condition: This symptom occurs if the receiving buffer size is modified.
To Next Page
Loading...
