EasyManua.ls Logo

HPE MSR1000 - Page 54

HPE MSR1000
371 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50
Condition: This symptom occurs if more than two VLANs exist and their VLAN interfaces are
assigned IP addresses.
201504230195
Symptom: On an IRF fabric, assertion information is displayed and subordinate routers reboot
when the IPv4 device is pinged from the IPv6 side.
Condition: This symptom occurs if the traffic processing unit for the AFT traffic of a VLAN
interface is not on the same forwarding card as the member interfaces of the VLAN interface.
201506090049
Symptom: The FCM card behaves unexpectedly.
Condition: This symptom occurs if FCM subinterfaces are deleted through MIB.
201507070310
Symptom: The link layer protocol of a DTE interface goes down.
Condition: This symptom occurs if the clock selection mode is set to autonegotiation for the
DTE interface.
201507010073
Symptom: The router reboots repeatedly after traffic statistics are cleared.
Condition: This symptom occurs if the following operations are performed:
a. Perform an active/standby switchover for HDLC interfaces that forward Layer 3 IP traffic.
b. Configure NetStream.
c. Enable the application statistics feature by using the application statistics enable
command.
201411030517
Symptom: Web redirection fails for a PPPoE user.
Condition: This symptom occurs if Web redirection parameters are assigned through RADIUS.
201503110069
Symptom: The VLAN ID sent to the RADIUS server is incorrect.
Condition: This symptom occurs if a QinQ PPPoE user comes online.
201503090276
Symptom: Users of a domain cannot be displayed or forcibly logged out.
Condition: This symptom occurs if the users come online without domain information.
201503110472
Symptom: Redirection fails after a PPPoE client issues a redirection attribute.
Condition: This symptom occurs if a PPPoE client issues a redirection attribute.
201503110566
Symptom: The redirection attribute issued through a COA message does not take effect.
Condition: This symptom occurs if the redirection attribute is issued through a COA message.
201507150201
Symptom: Assertion information appears when the pppoesd process is restarted on the L2TP
LNS.
Condition: This symptom occurs if a user comes online in NAS-initiated tunneling mode.

Table of Contents

Related product manuals