HPE ProLiant MicroServer Gen10

1
2. Open the front bezel.
3. To completely detach the bezel from the front panel, release the bezel hinges from the chassis.
Retain the bezel for later use.
1
2
Removing an unlocked front bezel
Prerequisites
1. Power down the server on page 22.
2. Disconnect the power cord from the AC source, and then from the server
.
3. Disconnect all peripheral cables from the server.
Procedure
1. Open the front bezel.
2. To completely detach the bezel from the front panel, release the bezel hinges from the chassis.
Retain the bezel for later use.
24 Removing an unlocked front bezel