HPE ProLiant MicroServer Gen10 User Manual

1
2
2. Verify that any switches or jumpers on the expansion board are set properly.
For more information, see the expansion board documentation.
3. Install the expansion board. Verify that the board is firmly seated in the slot.
1
2
Internal USB device options
The server has an internal USB 2.0 port that you can use to install internal USB devices such as:
• USB flash media devices for booting up from flash solutions or for data backup/redundancy.
•
USB devices that are intended to be rarely removed such as a USB dongle for Bluetooth or Wi‑Fi support.
Install an internal USB device
Procedure
1. Power down the server on page 22.
2. Disconnect the power cord from the AC source, and then from the server
.
3. Disconnect all peripheral cables from the server.
4.
Remove the chassis cover on page 26.
50 Internal USB device options

HPE ProLiant MicroServer Gen10 Specifications

General

Product Line	HPE ProLiant
Server Type	MicroServer
Maximum Memory	32 GB
Memory Slots	2
Expansion Slots	1 PCIe 3.0 x8 slot
Form Factor	Ultra Micro Tower
Processor	AMD Opteron X3000 series
Memory Type	DDR4 ECC UDIMM
Storage	4 LFF non-hot plug drive bays
Network	2 x 1GbE ports
Power Supply	200W Non-Hot-Plug, Non-Redundant Power Supply
Dimensions	23.5 x 23 x 25.4 cm
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Management	HPE iLO Standard
RAID Support	HPE Smart Array S100i SR Gen10 (RAID 0, 1, 10)