HPE ProLiant ML30 Gen10

To access the redundant ROM, set S1, S5, and S6 to On.
When the system maintenance switch position 6 is set to the On position, the system is prepared to restore all configuration settings
to their manufacturing defaults.
When the system maintenance switch position 6 is set to the On position and Secure Boot is enabled, some configurations cannot be
restored.
For more information, see Secure Boot.
DIMM label identificationDIMM label identification
To determine DIMM characteristics, see the label attached to the DIMM. The information in this section helps you to use the label to
locate specific information about the DIMM.
ItemItem DescriptionDescription ExampleExample
1 Capacity 8 GB
16 GB
32 GB
64 GB
128 GB
2 Rank 1R = Single rank
2R = Dual rank
4R = Quad rank
8R = Octal rank
3 Data width on DRAM x4 = 4-bit
x8 = 8-bit
x16 = 16-bit
4 Memory generation PC4 = DDR4
1
2
3
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 105