Charging other devices with your phone
You can use HTC U24 pro as a charger for other devices that support the Qi wireless standard. To
use this feature, you need to enable wireless reverse charging on your phone.
1. On the Home screen, tap Settings.
2. Tap Battery.
3. Turn on Wireless reverse charging.
4. Place the device you want to charge on the center of your phone, with their backs facing one
another.
Wireless reverse charging uses low power for charging. Charging speed or efficiency may vary
between different devices.
When you've finished charging, remove the other device from your phone.
Water and dust resistant
HTC U24 pro is water and dust resistant. It has an IP67 rating as defined in the International
Standard IEC 60529. With the nano SIM/microSD slot covered and closed tightly, the phone is
water resistant if it is briefly submerged by accident in fresh water less than 1 meter deep and no
longer than 30 minutes at room temperature.
HTC U24 pro must not be exposed to non-fresh water, high water pressure, strong or fast-moving
water, or sand since these may cause overheating, electric shock, or damage to the phone. Do not
attempt to charge or otherwise use the USB port when HTC U24 pro is wet. Normal wear and tear
may decrease the water and dust resistance over time.
Warranty will be void if the phone is not used in accordance with the instructions and precautions
addressed in this user guide, including, but not limited to, using the phone in environments or
situations that exceed the limitations of the IP67 rating. For usage precautions and tips on care and
maintenance, see Care and maintenance tips on page 41 and Cleaning and drying on page 43.
Also make sure to read the Safety guide that comes with the phone.
Care and maintenance tips
Follow these tips and precautions to help maintain water and dust resistance for your phone.
Never attempt to insert or remove the nano SIM and microSD cards with gloves, wet hands, or when
the phone is wet.
41 Getting the most out of your phone
To Next Page
Loading...
