Huawei E9000 - Page 31

ip address 192.168.100.123 255.255.255.0
#
return
[Fabric-MEth0/0/1]quit
[Fabric]quit
2. If the congured IP address and the FTP server address are not on the same
network segment, run the following command on the HMM CLI to congure
a gateway for the switching plane:
smmset -l swi N :fru M -d route -v targetvalue maskvalue gatewayvalue
The parameters are described as follows:
– N indicates the slot number of the switch module. The value range is 1 to
4, mapping to logical slot numbers 1E, 2X, 3X, and 4E from left to right
on the panel respectively.
–
M : indicates the ID of the switching plane. The value for the Ethernet
switching plane is 2.
–
targetvalue : indicates the target network segment IP address of the
switching plane.
–
maskvalue : indicates the subnet mask of the switching plane.
– gatewayvalue : indicates the gateway IP address of the switching plane.
For example, if the IP address is 192.168.112.1, run the following
command:
smmset -l swi3:fru2 -d route -v 0.0.0.0 0.0.0.0 192.168.112.1
Step 3 Obtain the log information.
1. Run the following command to collect logs.
<Fabric>display diagnostic-information diag-info.txt
Now saving the diagnostic information to the device
Info: The diagnostic information was saved to the device successfully.
<Fabric>save
logle
Save log le successfully.
2. View the log le system.
<Fabric>dir
Directory of ash:/
Idx Attr Size(Byte) Date Time(LMT) FileName
0 -rw- 1,075 Apr 01 2000 23:55:17 private-data.txt
1 -rw- 1,260 Apr 02 2000 00:00:13 hostkey
2 -rw- 540 Apr 02 2000 00:00:17 serverkey
3 -rw- 148,848 Sep 08 2015 11:22:40 diag-info.txt
16,129 KB total (15,976 KB free)
<Fabric>dir
ashvx:/logle/
Directory of ashvx:/logle/
Idx Attr Size(Byte) Date Time(LMT) FileName
0 -rw- 2,939,200 Apr 01 2000 23:55:02 log.dblg
1 -rw- 95,988 Jan 07 2014 19:16:00 2014-01-07.19-13-54.log.zip
2 -rw- 172,081 Jan 07 2014 21:35:14 2014-01-07.21-31-56.log.zip
3 -rw- 2,716,484 Jan 23 2014 01:35:24 log.log
4 -rw- 4,589,648 Jan 17 2014 12:30:48 2000-04-01.23-55-08.dblg
3. Enter the IP address, username, and password to log in to the FTP server. In
the following example, the FTP server address is 200.1.1.126 and the
username is root.
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 22