Huawei E9000 - Page 33

Prerequisites
Conditions
● WFTPD 4.2.4.610 or later has been installed on the PC.
● You have logged in to the Ethernet switching plane CLI. For details, see 8.15
Logging In to a Server Over a Network Port by Using PuTTY or 8.17
Logging In to a Compute Node, Passthrough Module, or Switch Module
by Using the SOL Function of the MM910.
Data
Table 4-6 describes the required parameters.
Table 4-6 Data list
Parameter Example Value
IP address CX911, CX311, and CX915: 192.168.1.100
CX912, CX210, and CX220: 10.77.77.77
Subnet mask 255.255.255.0
Default gateway 0.0.0.0
The default username of the switching plane is root, and the default password is
Huawei12#$.
NO TE
You can query and set IP addresses of all modules. For details, see 8.11 Logging In to the
MM910 WebUI.
● For the MM910 versions earlier than (U54) 2.20, choose System Management >
Network Management > xx > IP addresses.
● For the MM910 (U54) 2.20 or later, choose Chassis Settings > Network Settings >
xx .
Software Tools
wftpd32.exe: used to transfer
les between dierent platforms, for example, from
a PC to a switch module. This tool is third-party software. You need to prepare it
by yourself.
Procedure
Step 1
Congure the FTP server.
For details, see 8.20
Conguring an FTP Server.
Step 2 After logging in through the serial port or SOL function, run the following
commands on the Ethernet switching plane CLI to check whether the
management network port IP address has been
congured.
NO TE
Skip this step if you log in to the switch module by using a network port.
Huawei Servers
Troubleshooting 4 Collecting Information
Issue 20 (2020-09-25) Copyright © Huawei Technologies Co., Ltd. 24