Figure 6-95 Pulling out an enclosure
Step 4 Press the latch of the disk module and pull out the disk module, as shown in
Figure 6-96.
Figure 6-96 Removing a disk module
Step 5 Put the removed disk module into an ESD bag.
Step 6 Take the spare part out of its ESD bag.
Step 7 Open the latch of the spare part, insert the spare part, and close the latch, as
shown in Figure 6-97.
OceanStor V5 Series
Parts Replacement 6 Replacing CRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 98
To Next Page
Loading...
