Figure 8-21 Installing MCB copper bars
Step 3 Open the handles on both sides of the hot-swap base.
Step 4 Snap an MCB into the hot-swap base using the MCB extracting kit, and close the
handles on both sides.
Figure 8-22 Installing an MCB
Step 5 Install all other MCBs in the same way according to the capacity expansion
principles.
● The number of MCBs to be installed vary depending on site requirements.
● Each reserved label code corresponds to one 1P MCB. A 3P MCB takes up three label
codes.
Step 6 Reinstall the front panel.
Step 7 Tap Maint. on the System Info. screen to enter the Expansion Settings screen.
PDU8000 Modular Precision PDC V2.0
User Manual 8 Maintenance Guide
Issue 04 (2021-04-13) Copyright © Huawei Technologies Co., Ltd. 137
To Next Page
Loading...
