NOTE
The thermal compound injector has volume marks.
Apply thermal compound using any of the methods shown in Figure4 Pasting methods. The
two-line, five-point, S-shape, and X-shape methods are recommended.
Figure 7-78 Thermal compound application methods
Step 8 Use a clean card to smear the thermal compound over the entire center of the CPU.
The thermal compound layer is as thick as a common piece of paper. Figure 7-79 shows the
smeared thermal compound layer. Ensure that the thermal compound is evenly and fully
applied.
Figure 7-79 Smeared thermal compound layer
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 200
To Next Page
Loading...
