Step 9 Install the CPUs.
l To prevent damage to the CPU, CPU socket, or mainboard, ensure that the securing rod on
the CPU socket is fully open before you install the CPU in the socket.
l When you close the securing rod, do not exert excessive force or touch any components
and gild pins on the CPU.
l Do not move the CPU if it is not correctly placed to avoid any twisted pins. Lift the CPU
until it is out of the socket, and then place it in the socket properly.
l Installing a v3 series CPU
a. Squeeze two sides of the CPU installation tool and raise the tool with the CPU
inside. See Figure 7-80.
Figure 7-80 Raising a CPU installation tool with a CPU inside
b. Hold the CPU installation tool with the CPU inside horizontally, and place the tool
vertically downward into the CPU socket by avoiding touching the securing rods.
See step (1) in Figure 7-81.
Align the triangle on the CPU with the triangle on the CPU socket to ensure that the
CPU is properly installed.
Figure 7-82 shows a CPU that is incorrectly placed.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 201
To Next Page
Loading...
