Figure 7-130 Installing the VGA board on a server with eight 3.5-inch hard disks
Step 5 Tighten the screws to secure the VGA board to the panel. See step (2) in Figure 7-130.
Step 6 Connect cables to the VGA board.
Step 7 Push the panel into the server in the arrow direction. See step (3) in Figure 7-130.
Step 8 Tighten the screws on the server. See step (4) in Figure 7-130.
NOTE
If fan modules have been installed, remove the fan modules and their brackets before tightening the
screws.
Step 9 Connect all cables between the VGA board and the DVD drive. For details, see 2.7 Internal
Cabling.
Step 10 Install the fan module brackets in the chassis. See Figure 7-131.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 246
To Next Page
Loading...
