LUNA2000-200KWH-2H1 Smart String ESS
User Manual
A Crimping an OT or DT Terminal
Copyright © Huawei Technologies Co., Ltd.
Avoid damaging the core wire when stripping a cable.
The cavity formed after the conductor crimp strip of the OT or DT terminal has been
crimped must wrap around the core wires completely. The core wires must be in close
contact with the OT or DT terminal closely.
Wrap the wire crimping area with heat-shrink tubing or insulation tape. The heat-shrink
tubing is used in this section as an example.
Use a heat gun carefully to avoid heat damage to the equipment.
Figure A-2 Crimping an OT terminal
To Next Page
Loading...
