Huawei UPS5000-E-30 kVA-FM - Connecting an Ambient T;H Sensor

Figure 3-16 Securing the antiseismic kits to the cabinet
Step 3 Reinstall the rear panel.
Step 4 Adjust the cabinet position so that the expansion bolt holes are aligned with the
eight holes at the bottom of the cabinet.
Step 5 Secure the two antiseismic kits at the front and rear of the cabinet to the
oor
using eight M12 expansion bolts, as shown in Figure 3-17.
Figure 3-17 Securing the antiseismic kits to the oor
----End
3.3.3.2 Connecting an Ambient T/H Sensor
Procedure
Step 1 Connect the RJ11 port on the ambient T/H sensor to the COM1 port on the
monitoring interface card.
UPS5000-E-(30 kVA–120 kVA)-FM
User Manual 3 Installation
Issue 03 (2022-01-30) Copyright © Huawei Technologies Co., Ltd. 61