Huawei USG6000E Series - Page 335

Port Connector Type Description Available
Components
MGMT port RJ45 Out-of-band
10/100/1000M
RJ45 autosensing
Ethernet
management
port. The interface
number is METH
0/0/0 and the
default IP address
of the interface is
192.168.0.1.
You can connect
this port to the
network port or
any reachable
port on a PC
through a
network cable.
Then, you can use
Telnet to access
the CLI or use a
web browser to
access the web UI
to
congure,
manage, and
maintain the
device.
NOTE
The MGMT port
cannot be used as
a service port.
Ethernet Cable
100GE optical
ports (0 to 1)
QSFP28 Two 100GE
Ethernet optical
ports, numbered
100GE0/0/0 and
100GE0/0/1.
By default, the
100GE optical
port mode is
disabled. To
enable this mode,
run the set device
port-cong-mode
100g-port enable
command.
100Gbps QSFP28
Optical Modules
HUAWEI USG6000E Series
Hardware Guide 4 Hardware Overview
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 328