Use a Phillips screwdriver to x the mounting ears to both sides of the chassis
with M4 screws. The maximum torque is 1.4 N m. For details about how to install
the mounting ears, see the installation methods in Table 5-4.
● The front mounting brackets, rear mounting brackets, and rear mounting bracket guide rails
must be installed on both sides of the USG. Table 5-4 shows the installation on one side.
Install them on the other side in the same way.
● To ensure
sucient cabling space, reserve at least 130 mm of vertical distance from the
USG's port side to the interior side of the cabinet door.
● After the installation is complete, the rear mounting brackets and rear mounting bracket
guide rails will not block cables routed from the ports or touch the cabinet door.
Table 5-4 Installation of front and rear mounting ears
Distance Between
Front and Rear
Mounting Rails
Installation of Front Mounting Brackets, Rear
Mounting Brackets, and Rear Mounting Bracket
Guide Rails
310 mm to 351 mm
369 mm to 410 mm
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 537
To Next Page
Loading...
