Distance Between
the Front and Rear
Mounting Bars and
Cabinet Type
Expandable Rear Mounting Ears and Adjustable
Guide Rails
Adjustable guide
rails (BOM number:
21242246)
● Distance between
the front and rear
mounting bars:
500 mm to 850
mm
● Cabinet depth:
1000 mm to 1200
mm
● The position for the USG in the cabinet is well arranged. Ensure that the USG
is 1 U of clearance from any devices above and below and 150 mm of
clearance from any devices on the right or left.
● The USG to be installed is staged near the cabinet for convenience.
● In the front view, the air ow of the USG is front to rear. If the USG and a
device whose air
ow is rear to front must be mounted in the same cabinet,
maintain certain spacing between them to prevent hot air recirculation.
You can place either end of the USG chassis towards the front door of the cabinet.
In this manual, the front panel of the USG is towards the front door of the
cabinet.
The method of installing expandable rear mounting ears (BOM number: 21240492) is the
same as that of installing expandable rear mounting ears (BOM number: 21240538). The
following uses the expandable rear mounting ears (BOM number: 21240492) as examples.
Tools and Accessories
● Phillips screwdriver
● Floating nuts and matching screws
● Floating mounting bar
● Front mounting ears and corresponding screws
● Expandable rear mounting ears and corresponding screws (purchased
separately, BOM numbers: 21240492 and 21240538)
● Adjustable guide rails and matching screws (purchased separately, BOM
numbers: 21242247 and 21242246)
Procedure
Step 1 Install mounting ears on the chassis.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 563
To Next Page
Loading...
