If the USG has hard disks, do not power o the USG by removing the power
cable or switching o the power supply to prevent data loss and hard disk
damage. You must run the disk oine command in the system view rst and
wait for about 30 seconds. After the system prompts you with a message
indicating that hard disks have stopped, turn
o the power switch of the USG.
----End
Follow-up Procedure
After the USG is powered on, you can log in to the
conguration page for
management and maintenance. For details, refer to the Conguration Guide.
HUAWEI USG6000E Series
Hardware Guide 5 Hardware Installation
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 579
To Next Page
Loading...
