Huawei USG6000E Series - Page 588

not run the disk oine command. The following procedure guides you through
hard disk replacement while the USG is powered on:
Step 1 Ensure that all congurations are saved.
Step 2 Run the disk oine command in the system view. Wait about 30 seconds until
the system indicates that the hard disk stops working and then remove the hard
disk to be replaced.
NO TE
If you remove and insert a hard disk without running the disk oine command rst, the
hard disk may be damaged, data in the hard disk may be lost, or the system may stop
responding to services.
1. Use the handler to pull the hard disk out of the slot.
2. Put the replaced hard disk into an ESD bag.
Figure 6-1 Removing the hard disk (USG6515E, USG6525E, USG6550E,
USG6555E, USG6560E, USG6565E, USG6580E, USG6585E)
Step 3 Install the new hard disk, see Installing the Hard Disk.
Step 4 Run the disk online command in the system view and then the display disk
information command. If Filesystem Status is Mounted, the hard disk works
properly.
----End
HUAWEI USG6000E Series
Hardware Guide 6 Maintaining the Hardware
Issue 08 (2022-04-20) Copyright © Huawei Technologies Co., Ltd. 581