MAXPRO200 Instruction Manual 807700 Revision 1 55
Installation
Torch mounting and alignment
Mounting the torch
1. Install the torch (with torch leads attached) in the torch mounting bracket.
2. Position the torch below the mounting bracket, so that the bracket is around the lower portion of the torch sleeve but
not touching the torch quick-disconnect.
3. Tighten the securing screws.
Note: The bracket should be as low on the torch sleeve as possible to minimize vibration at the tip of the torch.
Torch alignment
To align the torch at right angles to the workpiece, use a square as shown above.
1 Torch sleeve
2 Mounting bracket
3 Quick-disconnect receptacle
To Next Page
Loading...
