Hypertherm Powermax 65 Operator's Manual

OPERATION
4-2 powermax 65/85 Operator Manual
Using the machine torch ................................................................................................................................4-24
Ensure the torch and table are set up correctly .............................................................................4-24
Understand and optimize cut quality .................................................................................................4-24
To pierce a workpiece using the machine torch ............................................................................4-27
Common machine-cutting faults ........................................................................................................4-27

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch