Hypertherm Powermax 65 Operator's Manual

powermax 65/85 Operator Manual 5-1
Section 5
MAINTENANCE AND REPAIR
In this section:
Perform routine maintenance .......................................................................................................................... 5-2
Inspect the consumables ................................................................................................................................. 5-3
Basic troubleshooting ....................................................................................................................................... 5-4
Fault codes and solutions ................................................................................................................................ 5-6
Replace the gas filter element ......................................................................................................................5-10

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch