Hypertherm Powermax 65 Operator's Manual

POWER SUPPLY SETUP
2-2 powermax 65/85 Operator Manual
Unpack the Powermax65 or Powermax85 system
1. Verify that all items on your order have been received in good condition. Contact your
distributor if any parts are damaged or missing.
2. Inspect the power supply for damage that may have occurred during shipping. If there is
evidence of damage, refer to “Claims” below. All communications regarding this equipment
must include the model number and the serial number located on the back of the power
supply.
3. Before you set up and operate this Hypertherm system, read the separate Safety and
Compliance Manual included with your system for important safety information.
Claims
• Claims for damage during shipment – If your unit was damaged during shipment,
youmust file a claim with the carrier. Hypertherm will furnish you with a copy of the bill
oflading upon request. If you need additional assistance, call the nearest Hypertherm
office listed in the front of this manual.
• Claims for defective or missing merchandise – If any component is missing or
defective, contact your Hypertherm distributor. If you need additional assistance, call
thenearest Hypertherm office listed in the front of this manual.

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch