Hypertherm Powermax 65 - Attach the Work Clamp to the Workpiece

OPERATION
powermax 65/85 Operator Manual 4-11
Attach the work clamp to the workpiece
The work clamp must be connected to the workpiece while you are cutting. If you are using the
Powermax65 or Powermax85 with a cutting table, you can connect the work lead directly to
the table instead of attaching the work clamp to the workpiece. See your table manufacturer’s
instructions.
Note the following:
• Ensure that the work clamp and the workpiece make good metal-to-metal contact.
Remove rust, dirt, paint, coatings, and other debris to ensure the power supply makes
proper contact with the workpiece.
• For the best cut quality, attach the work clamp as close as possible to the area being cut.
• Do not attach the work clamp to the portion of the workpiece to be cut away.
Work clamp