Hypertherm Powermax 65 Operator's Manual

SPECIFICATIONS
powermax 65/85 Operator Manual 1-3
Where to find information
System specifications such as size, weight, detailed electrical specifications, and cut speeds can
be found in this section. For information on:
• Setup requirements, including power requirements, grounding, power cord configurations,
extension cord requirements, and generator recommendations — see Section 2, Power
Supply Setup.
• Handheld and machine torch consumables, cut charts, and torch setup information — see
Section 3, Torch Setup.
• Information about the controls and LEDs, steps for system operation, and hints for
improving cut quality — see Section 4, Operation.
• Routine maintenance and repair — see Section 5, Maintenance and Repair.
• Part numbers and ordering information for accessories, consumables, and replacement
parts — see Section 6, Parts.

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch