POWER SUPPLY SETUP
powermax
65/85
Operator Manual 2-9
Single-phase power cord (not for CE model)
To operate your Powermax85 on 1-phase power, you will need to install an appropriate power
cord. Refer to “Single-phase power cord installation” on page 2-10 for instructions.
aution:C When using the Powermax85 CSA model power supply (CE
model is 3-phase only) with a 1-phase power source, replace
the supplied power cord with a 6 AWG (16 mm
2
) 3-wire
power cord. The power cord must be connected by a licensed
electrician.
To Next Page
Loading...
