Hypertherm Powermax 65 - Common hand-cutting faults

OPERATION
4-22 powermax 65/85 Operator Manual
Varying the gouge profile
The following actions have the stated effects on the gouge profile:
• Increasing the speed of the torch will decrease width and decrease depth.
• Decreasing the speed of the torch will increase width and increase depth.
• Increasing the standoff of the torch will increase width and decrease depth.
• Decreasing the standoff of the torch will decrease width and increase depth.
• Increasing the angle of the torch (more vertical) will decrease width and increase
depth.
• Decreasing the angle of the torch (less vertical) will increase width and decrease
depth.
• Increasing the current of the power supply will increase width and increase depth.
• Decreasing the current of the power supply will decrease width and decrease
depth.