Hypertherm Powermax 65 Operator's Manual

PARTS
powermax 65/85 Operator Manual 6-7
Part number Description
058503 O-ring
075504 Pilot terminal screw
228719 Kit: H65/H85 Cap-sensor switch replacement
228109 Kit: H65s/H85s Cap-sensor switch replacement
228722 Kit: H65/H85 Torch lead replacement, 10 ft (3.0 m)
228723 Kit: H65/H85 Torch lead replacement, 25 ft (7.6 m)
228724 Kit: H65/H85 Torch lead replacement, 50 ft (15.2 m)
228725 Kit: H65/H85 Torch lead replacement, 75 ft (22.9 m)
228726 Kit: H65s/H85s Torch lead replacement, 10 ft (3.0 m)
228727 Kit: H65s/H85s Torch lead replacement, 25 ft (7.6 m)
228728 Kit: H65s/H85s Torch lead replacement, 50 ft (15.2 m)
228729 Kit: H65s/H85s Torch lead replacement, 75 ft (22.9 m)
005252 Trigger start switch

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch