Hypertherm Powermax 65 Operator's Manual

PARTS
powermax 65/85 Operator Manual 6-13
Part number Description
FineCut 45 A
1
220955 Deflector
220948 Shield
220854 Retaining cap
220953 Ohmic retaining cap
220930 Nozzle
220842 Electrode
220857 Swirl ring
1
The deflector (220955) is used only with the standard retaining cap (220854). The shield
(220948) is used only with the ohmic retaining cap (220953).

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch