www.hysecurity.com General Maintenance D0559 Rev. A 85
eleCtrICal Controls
NOTICE: Before servicing, turn off all power switches.
No routine maintenance is needed for the electrical system or controls. If the environment is very sandy or dusty,
or has many insects, be certain to seal all holes in the electrical enclosure. Blow the dust out of the electric panel
with compressed air. Use the troubleshooting Table 3 on page 78 to assess and x error, alert, and fault codes. If it
is necessary to call a distributor for assistance, be sure to have your model and serial number ready. Other helpful
information includes the name of the job, approximate date of installation, and the service record of the operator,
especially if any work has been done recently.
Clock Battery Replacement
A lithium coin battery supports the clock, so the date and time is
retained even when the main power is turned off. Replace the battery
about every ve years (or as needed) with a DL 2025, DL 2032, or CR
2025, or CR 2032 battery.
meCHnICal Controls
Stopping the Gate
Most models (except SlideDriver 15 and 40) employ a time delay Soft Stop system.
Additionally, brake valves are used to control the stopping of heavy or fast moving
gates. These valves are exclusive to HySecurity operators. They are independently
adjustable to allow the gate to stop predictably and without banging.
Starting the Gate
To accommodate for loads moving beyond one foot per second, it is necessary to Soft
Start the load gently and stop it smoothly. HySecurity accomplishes Soft Start with
another exclusive feature we call an Accumulator With Out Gas (AWOG), which diverts
some of the start-up hydraulic ow, accommodates for the load, and starts the gate
smoothly, similar to letting your foot slowly off a car clutch without any lurching.
The downward facing AWOG (shown right) improves the life and performance of a gate
system and never needs adjustment.
USER 3
VEHICLE DETECTOR
OUTSIDE
OBSTR
COM
NO
STATU S
Battery
AWOG
To Next Page
Loading...
Need help?
General
