4 D0559 Rev. A SlideDriver/SlideDriver 50VF Series www.hysecurity.com
A moving gate or barrier arm, bollard, or wedge can cause serious injury or death.
To reduce the risk of injury or death:
1. READ AND FOLLOW ALL INSTRUCTIONS. Read the gate operator’s product manual and review all the
product labels and literature prior to installing, operating, or maintaining the automatic gate operator.
2. Never let children operate or play with gate controls. Keep all remote controls, especially radio
transmitters, away from children. Do not allow children to play on or around the gate or gate operators.
3. Always keep people and objects away from the gate. NO ONE SHOULD CROSS THE PATH OF THE
MOVING GATE. Start the gate operator only when a gate’s travel path is clear.
4. Test the gate operator monthly. The gate MUST reverse on contact with a rigid object or stop when an
object activates the non-contact sensors. After adjusting the force or the limit of travel, retest the gate
operator. Perform routine tests of the entrapment protection sensors, such as photo eyes and gate edges.
Failure to adjust and retest the gate operator properly can increase the risk of injury or death.
5. Use the emergency release only when the gate is not moving.
6. KEEP GATES PROPERLY MAINTAINED. Read the product manuals. Have a qualied service person make
repairs to gate hardware and replace batteries in accessory or entrapment sensory devices on a regular
basis.
7. The automated gate entry is for vehicle use only. Pedestrians must use a separate entrance. Make sure a
separate walk-through entrance is nearby. Make certain a clear pedestrian path is designated and signs
direct pedestrians to the walk-through gate.
8. Install the supplied WARNING signs on the inside and outside of the gate or barrier gate/operator so they
are clearly visible from both the secure and public sides. Installing the signs is a requirement for UL 325
compliance.
Safety - Additional Installer Responsibility
• Verify the gate operator usage class for the site. For all gate operators other than Crash-rated, refer to
Identifying Gate Operator Category and Usage Class in this product manual. Install the operator only
when the gate operator class is correct for the site, size, and type of gate.
• The gate operator must be properly grounded and the incoming power voltage must match the voltage
label on the junction box.
• Install an automatic operator only on gates that comply with ASTM F2200 Gate and Fence Standards.
Screen or enclose openings in the gate per UL 325 Safety Standards which include:
All horizontal slide gates must guard or screen openings from the gate’s base support to a minimum
height of 6 feet (183 cm) above the ground. This must prevent a sphere of 2¼-inches (57 mm) in
diameter from passing through an opening in the gate or the adjacent fence that is covered in the
gate’s open position.
Physical stops must exist in the gate construction to prevent over-travel in both directions and, for
slide gates, guard posts must be installed to prevent the gate from falling in the event of a roller
failure.
To Next Page
Loading...
Need help?
General
