23
Initiating an All Call
Through Preset Contact
Press and then rotate the Smart Knob to select the channel or all call contact.
Press and hold the PTT key.
Through Manual Dialing
Tap .
In the Dialer interface, enter the all call ID complying with the dialing rules.
Tap or press the PTT key.
Through Contact List
Tap or .
Go to Contacts > Group, and then tap the all call contact.
Press and hold the PTT key or tap .
Through One Touch Call
With the One Touch Call feature enabled, do either of the following:
In trunking mode, press the preprogrammed One touch call/msg key.
In conventional mode, press the preprogrammed One touch call/msg key, and then press the PTT key.
Receiving an All Call
You can answer an all call without any operation.
Ending an All Call
Conventional Mode
An all call ends when the calling party releases the PTT key.
Trunking Mode
An all call ends in one of the following cases:
The calling party taps or presses the On-Off/End key.
If the called party presses the On-Off/End key, the called party exits the call, and can rejoin the call later.
The preset transmission time of the calling party expires.
To Next Page
Loading...
