EasyManua.ls Logo

Hytera PDC760 - 5.7.1 Initiating an Emergency Service

Hytera PDC760
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
49
Emergency Type
Description
Silent w/Voice
The radio gives audible indications only upon receiving a call. Otherwise, the radio
gives no audible or visible indication.
Alarm w/Siren
The radio transmits the emergency signal to the control center, and then emits a
siren.
In addition, if the emergency type is Regular, Silent, or Silent w/Voice, you can request your dealer to set one
of the following emergency modes:
Emergency Mode
Description
Call Only
You can only initiate an emergency call.
Alarm w/Call
You can only send an emergency code and initiate an emergency call.
Alarm You can only send an emergency code.
5.7.1 Initiating an Emergency Service
With the Emergency feature enabled by your dealer, you can press the preprogrammed Emergency on key
(short press TK by default) to initiate an emergency service.
If the Alarm w/Call To Follow feature is enabled by your dealer, you can speak into the microphone without
pressing and holding the PTT key. If the preset voice cycles expire, you can press and hold the PTT key to
initiate the emergency call again.
5.7.2 Receiving an Emergency Call
You can answer an emergency call without any operation.
5.7.3 Ending an Emergency Service
Conventional Mode
An emergency service ends when the service initiator presses the preprogrammed Emergency off key (long
press TK by default).
Trunking Mode
An emergency service ends in any of the following cases:

Table of Contents

Other manuals for Hytera PDC760

Related product manuals