Hytera PDC760 - 5.2.2 Trunking Mode

44

Setting the scan list
The scan list is a list of analog and digital channels that the radio scans.
To set the scan list, do as follows:
a. Tap or , and then tap Contact.
b. Tap Zone, and then tap the channel.
c. Tap to edit the scan list.
5.2.2 Trunking Mode
Pre-registration Hunt
Before registering, the radio hunts through the control channels for available BSs. The hunting plans include
Fixed Trunking Station Control Channel (Fixed TSCC) and Flexible Trunking Station Control Channel (Flexible
TSCC). If the radio has unified frequency plans, it uses the Fixed TSCC; otherwise, it uses the Flexible TSCC.
With the Fixed TSCC preset, you can select one of the following hunt modes.
Hunt Mode
Description
Operation
Short Hunt
This feature allows the radio to hunt the fixed TSCC in the
defined hunt list.
Tap
, and then go to
Scan > Scan mode, and
then tap Short hunt,
Comprehensive hunt,
or Team hunt.
Comprehensive
Hunt
This feature allows the radio to hunt all the channels
within the preset frequency range.
Team Hunt
This feature allows the radio to hunt the fixed TSCC in the
defined team hunt list.
Post-registration Hunt
After successful registration, you can hunt again by pressing the preprogrammed Manual Current Hunt key.
To ensure seamless communications, you can adopt one of the following hunt modes.
Hunt Mode
Description
Operation
Background
Hunt
This feature allows an idle radio to keep detecting the signal
strength of the BS with which it registers. If the signal strength
goes below the threshold level preset by the dealer, the radio
will automatically hunt for an adjacent BS with stronger signal
strength and register with it.

Tap , and then
tap Scan to enable
Background hunt,
Home station hunt,
or Handover.