Hytera PDC760 - 5.3 Roam; 5.3.1 Conventional Mode

45
Hunt Mode
Description
Operation
Home
Station
Hunt
In a BS overlapping area, this feature allows the radio to
switch back to the home station channel when its signal
strength reaches the preset threshold. It is recommended that
you set your frequently used channel as the home station
channel.

Press the
preprogrammed
Background hunt,
Home station hunt,
or Handover key.
Multi-site
Handover
The signal strength received from a BS may fluctuate due to
position change, affecting the communication quality of the
radio. On such occasions, this feature allows the radio to
automatically register with the BS with stronger signal.
5.3 Roam
5.3.1 Conventional Mode
The Roam feature allows the radio to automatically select base stations with strong signal. This ensures
seamless communication across sites or networks. With the Roam feature enabled by your dealer, you can
do either of the following:

Enabling the Roam Feature
 In the control and notification center, tap the control widget of Roaming.
 Press the preprogrammed Narrowband roaming key.
 Tap , and then tap Roaming.
 Switch to the channel configured with the Auto Roam feature.
With the Roam feature enabled, the radio roams according to the roam list.

Setting the Roam List
The roam list is a list of digital channels where the radio roams. To set the roam list, do as follows:
a. Tap or , and then tap Contact.
b. Tap Zone, and then tap the channel.
c. Tap to edit the roam list.
The Scan and Roam features cannot be enabled for the same digital channel simultaneously.