What causes C6b error on IAI X-SEL Controller?
The C6b error on your IAI Controller indicates that the operation is mechanically disabled. Check to see if the actuator mounting bolts are contacting inside the axes, or if the slider attachment is contacting any surrounding mechanical parts.
What to do if IAI X-SEL displays dSF error?
If your IAI Controller displays the 'dSF' error, it means the switch is set to the manual side when the teaching connector or another connector is not connected. To fix this, set the switch to the auto side when no connector is connected.
What to do if IAI Controller shows ErG error?
The ErG error on the IAI Controller indicates that an emergency-stop signal is being input. This can occur if: the emergency-stop button on the teaching pendant is pressed; the applicable input terminal in the system connector is turned ON; the port switch on the front panel is set to the manual side without the teaching-pendant/PC-software connector connected; or, if the actuator is of sensor specification and the slider is stopped on either end of the slider. To resolve this, review these conditions and take the necessary corrective actions.
What does CA5 error mean on IAI X-SEL?
The CA5 error on the IAI Controller indicates a mechanical issue or a faulty power stage board. First, check if the actuator mounting bolts are contacting inside the axes or if the slider attachment is contacting any surrounding mechanical parts. If the mechanical function is fine, the power stage board is likely faulty and needs replacement.
General| Brand | IAI |
|---|---|
| Model | X-SEL |
| Category | Controller |
| Language | English |
To Next Page
