Function Code 9: Display Error Code Log
Function Code A: Clear Error Code Log
Function Code C: Insert Cartridge into Tape Drive
Function Code E: Test Cartridge & Media
Function Code F: Write Performance Test
Function Code H: Test Head
Function Code J: Fast Read/Write Test
Function Code L: Load/Unload Test
Function Code P: Post Error Reporting Enabled
Function Code U: Post Error Reporting Disabled
Error Codes and Messages
Troubleshooting
Clean Indicator is On
Tape Drive will not eject a Tape Cartridge
Fault LED is Flashing
The Fault LED is On Solid
Tape Drive Does Not Accept a Cartridge
The Host System Backup Application is Reporting an Error
Using LTO Ultrium Media
Cartridge Memory Chip (LTO-CM)
Loading and Unloading a Tape Cartridge
Loading a Tape Cartridge
Unloading a Tape Cartridge
Cleaning the Tape Drive
Types of Tape Cartridges
Recommendations for Data Cartridge Usage
Data Cartridge Erasure
Storage and Shipping Environments
Tape Cartridge Storage
Operating in Harsh Environments
Setting the Write-Protect Switch
Guidelines for Using Labels on Ultrium Cartridges
Placing the Cartridge Labels
Ordering Tape Cartridges
Reattaching a leader pin in an Ultrium cartridge
The Half High LTO-6 Tape Drive Feature
LTO Features
Feature Kit Contents
Operation Features
Unload Button
Indicator LEDs
Status LEDs
Single Character Display (SCD) Panel
Rear View of the LTO Tape Drive
Operating the LTO-6 Tape Drive
Operating Modes
Single-Character Display (SCD)
SCD Dot
Status LEDs
Unload Button
Diagnostic and Maintenance Functions
Entering Maintenance Mode
Exiting Maintenance Mode
Function Code 0: Maintenance Mode
Function Code 1: Run Drive Diagnostics
Function Code 4: Force a Drive Dump
To Next Page
Loading...
Need help?
General
