6. Power on the 7226 Storage Enclosure.
7. Refer to your system manuals to verify installation.
Servicing the 7226 Storage Enclosure is now complete.
Manually Removing Storage Media
Manually Removing a DAT160 Tape Cartridge
Manually Removing a Half High LTO-5/LTO-6/LTO-7/LTO-8/LTO-9 Tape Cartridge
Manually Removing a DVD Disc from the Drive
Manually Removing a DAT160 Tape Cartridge
Attention: The procedure for manually removing a tape cartridge could damage your tape cartridge, the tape drive, or both. Use
this procedure only after you have:
1. Tried the Unload command (if available) from your system command menu.
2. Attempted an emergency eject of the cartridge by pressing and holding the eject button for at least 5 seconds.
3. Attempted a drive reset by pressing and holding the eject button for at least 20 seconds.
4. Turned the power to the 7226 Storage Enclosure off and on again to clear potential hang conditions.
5. Disconnected the 7226 Storage Enclosure from the system, and turned the power to the 7226 Storage Enclosure on and
off again several times.
The following procedure describes how to manually remove a data cartridge from the tape drive. If this procedure is
performed, replace the drive, discard the used media, and use new media.
1. Remove the drive from the 7226 Storage Enclosure (see Replacing a Tape Drive Feature or a Removable Disk Drive
Feature).
To Next Page
Loading...
Need help?
General
