IBM Aptiva - Power Supply (2138 Only)

Repair Information 4-15
Power Supply (2138 only)
•
Rotate the feet of the system unit inward.
•
Position the unit so it lies flat on the table.
•
Release the cable tie that secures the power supply cables.
NOTE
: Please refer to the note on Bays 1, 2, 3 (5.25-In. Internal/External
Bays) on page 4-9.
•
Remove the screw that secures the power supply to the chassis. See step
1 in the figure below.
•
Locate and press the tab on top of the power supply frame. See step 2 in
the figure below.
•
Firmly hold the power supply frame and pull it toward the front of the
system unit. See step 3 in the figure below.
Figure 4- 14 Remove the power supply
•
Carefully place the power supply on top of the disk drive frame.
•
Detach the power supply from the frame by releasing 4 screws.