5-18
Power Supply Cable Connector Specifications
Refer to the following figures when checking for voltages on power supply
cable connectors.
When checking voltages, the power supply fan must be running. To power-on
the power supply without using the on/off switch, use a screwdriver or other
tool to short the connector CN14 (with the switch cable disconnected from the
connector on the system board) or use a connection (jumper) to short the
black and white wires of the standby power cable on power supply.
Figure 5- 5 System Board Power Supply Connectors
Figure 5- 6 Hard Drive or CD-ROM Power Cable Connector
To Next Page
Loading...
