2-32
Audio (Not Supported by Diagnostics Program)
NOTE:
While performing this check, you may need to enter and exit
Microsoft Windows 95 several times. When instructed to select an
icon or button, double-click on the item with the mouse.
For more information about using Microsoft Windows 95, see the
user's guide that came with the computer.
If an operating system other than Microsoft Windows 95 is installed,
the program screens and icons may differ from these instructions.
001 - START
−
Power off the system unit.
−
Remove all adapter cards.
−
Connect a hard disk drive with pre-loaded Windows 95 inside.
−
Power on the system unit.
002 - DO ANY POST MESSAGES, ERROR CODES, BEEPS, OR
SYMPTOMS APPEAR? (YES, READ AHEAD. NO, GO TO STEP
003)
−
Go to “Index of Symptoms, Messages, Error Codes, or Beeps” on
page 2-8.
−
End.
003 - DO ANY MESSAGES OR ERROR CODES DISPLAY AFTER POST
COMPLETES BUT BEFORE MICROSOFT WINDOWS 95 STARTS?
(YES, READ AHEAD. NO, GO TO STEP 004)
NOTE:
If POST does not complete, answer this question "No."
−
Ensure that Windows 95 is properly installed.
−
End.
004 -
−
Perform the following under Windows 95.
To Next Page
Loading...
Need help?
General
